Can Onkyo Reciver Feed Bose Acoustimass System

Q: I have a Bose Acoustimass 10 system, and would like some advice for finding a suitable A/V receiver to match the specs of the Bose in terms of wattage and ohms.

A: Glancing at the specifications of the Bose Acoustimass 10, the system is stated to be compatible with A/V receivers and amplifiers rated from 10-200 watts per channel, and from 4 ohms to 8 ohms. Those familiar with amplifier ratings might note that this represents a very wide range; however, the takeaway here is that the Bose system can used with entry level receivers.

While that's an easy enough answer, there's an obvious follow on question: is there any benefit to buying a higher end A/V receiver for use with the Acoustimass 10? The answer here is a little more complicated. Generally speaking, costlier receivers come with more power, better quality components (i.e. DACs), and of course more features. Obviously if you want a receiver with bells and whistles like built in WiFi, you'll need to spend more than bottom dollar. On the other hand, we wouldn't suggest buying a high end AVR for the sake of additional power or qualitative advantages unless you actually plan on replacing your Bose speaker system with something of higher quality.

Priced at $249, the Denon AVR-S500BT is a solid entry level AVR, packing 70WPC of amplification, 5 HDMI inputs, and integrated Bluetooth.

While Bose Acoustimass and Lifestyle systems are popular solutions for folks who want their speakers to disappear into their living room, there are limitations inherent to the form factor. In terms of power handling and overall volume capability, a Bose cube simply can't compete against a traditional two-way bookshelf speaker like an NHT SuperZero for example. While you might be able to connect the Acoustimass 10 to a 200W amplifier / receiver without worrying that the system will spontaneously burst into flame, the cubes simply won't be able to make use of that kind of power. In terms of audio quality, we would again suggest that the Bose speakers are a limiting factor. The use of 2.5" drivers limits the cubes' operating bandwidth and introduces various problems including cone breakup at higher frequencies. In this case, buying a receiver for an upgraded DAC is akin to throwing a gallon of water on a 100 acre forest fire: it won't accomplish anything.

Summary

If you own a Bose Acoustimass system, the vagueness of the included specifications may leave you wondering what A/V receiver would be appropriate for your setup. While we would not dissuade you from spending a few extra dollars on desirable features, in this case we would advise against spending big bucks on a receiver to gain extra power or qualitative improvements. While the use of 2.5" drivers allows Bose to offer extremely small satellite speakers, this exacts a price in terms of power handling and fidelity. As such, our recommendation is simply to spend what's needed for the features you desire, but nothing more.

beakergeek posts on September 07, 2014 08:40

I would sell it on ebay and get some better speakers. Bose systems are the most over priced low quality speakers on the market. Good sound rarely comes from a cube speaker.

rnatalli posts on August 19, 2014 21:15

Orbs or Mirage Nanosats were always my recommended alternatives. They obviously aren't as good as larger speakers, but for small speakers they do a far better job than Bose cubes. The Kef T series are nice too as they're incredibly flat and easy to make disappear in a room.

zieglj01 posts on August 18, 2014 18:52

rojo, post: 1046534
It should be noted that "higher quality" does not necessarily mean more expensive, or even as expensive. There are better speakers to be had costing less than the Bose.

Higher quality can be had for less - and there are better options than Bose.

However, some cube speakers can be quite expensive - and even have 10 inch drivers!

However, more expensive and bigger drivers - may turn some back to Bose.

Zu Audio Cube speakers for $499 each. However, not a fan of the measurements or the
poor bass response -3 db at 310 hz. The Bose cubes did maybe a little better in the bass
response. However, the Zu Audio will have good high sensitivity and more highs.

Now who wants to recommend a receiver - or even ask for a recommendation?

Zu Audio Cube Speaker System | Sound & Vision

rojo posts on August 18, 2014 08:37

Edit: I was being silly earlier and originally suggested an Emotiva pre-amp with Dirac Live. Using Dirac to correct a bunch of Bose dipoles gave me some amusement, like putting a humidifier and a dehumidifier into the same room to battle it out Steven Wright style.

But it appears the Bose system uses high level inputs into the bass module for its satellites, but not as a passthrough? The satellites connect to the bass module via RCA. How… odd.

Anyway, to answer the question posed by the article, just get a refurb Denon from Accessories4less. Doesn't really matter which. Get whichever one has the features you like.

Steve Munz
On the other hand, we wouldn't suggest buying a high end AVR for the sake of additional power or qualitative advantages unless you actually plan on replacing your Bose speaker system with something of higher quality.

It should be noted that "higher quality" does not necessarily mean more expensive, or even as expensive. There are better speakers to be had costing less than the Bose.

BoredSysAdmin posts on August 18, 2014 08:26

Kudos to Steve on how he accurately and very politely defined Bose speakers.

TL;DR -they are obiviusly crud

grossmestans1945.blogspot.com

Source: https://www.audioholics.com/frequent-questions/bose-speakers-what-receiver